MAXON’s Electro-Pneumatic Shut-Off Valves are ideally suited for reliable shut off of various fuel gases and liquids. MAXON gas valves require only a power source from your burner management system or DCS and an instrument air feed. MAXON shut off valve operating pressures and valve Cv’s are among the highest available in the industry meaning you can move more fuel in smaller size valves than competitive products.
Electrically actuated valves with powerful closing spring provide closure in less than 1 second for reliable, long-life operation
Factory Mutual, CSA, UL and CE approved; Canadian registration obtained on all valve bodies
Hazardous Locations valves approved for Non-incendive Class I, Division 2 areas
Full assessment to IEC 61508 as SIL 3 capable
Cast iron, carbon steel, low temperature carbon steel and stainless steel body assemblieswith internal trim options to handle general purpose or corrosive gases; oxygen compatibility available
Ambient and gas temperature ranges of -20°F to 140°F
Unique bonnet design eliminates packing adjustments, reducing maintenance and minimizing drag on closing
MAXON electro-mechanical gas valves meet Fluid Control Institute (FCI) 70-2 control valve standard for Class VI seat leakage
Field rotatable top assemblies in 90° increments to fit specific application requirements
Actuator assemblies available with manual reset or automatic reset operators
Normally-closed and normally-open versions available
MAXON burner sleeve gasket is to be installed between the main burner flanges and the oven wall. Designed to provide an airtight seal around the burner flange under the most extreme conditions, the burner sleeve gasket must be installed on all applications with position combustion chamber pressures. The gasket is considered a consumable item and should be replaced during regularly scheduled burner maintenance.
MAXON spark ignitors have been engineered specially for industrial burner applications. Quality construction provides maximum service life and dependable operation to keep your heating process running smoothly. Consult technical bulletins to ensure your setup is per manufacturer`s recommendation for your specific OP2 model.
MAXON guide tubes allow for the simple installation of either UV flame detection cells of flame rods. Designed to penetrate through the entire burner to visualize the flame directly of the nozzle tip, the carbon steel guide tubes are available with either NPT or TEC end connections.
MAXON red foam filters allow for the removal of particulates from the combustion air stream. The filters are specifically designed for the combustion industry and include a flame retardant to ensure safe operation in a variety of applications.
MAXON housing gasket is to be installed between the two (2) main casing sections of the burner. Designed to provide an airtight seal between the casing pieces, this gasket should provide a worry free seal under a variety of environmental conditions. The gasket is considered a consumable item and should be replaced during regularly scheduled burner maintenance.
MAXON observation glass allows for proper viewing of flame quality through the back plate of the burner. Includes two (2) sealing o-rings and is available in standard plexiglass or high temperature Quartz models.
MAXON pilot orifice valve allows for minute adjustments to the pilot capacity to ensure reliable and strong lightoff under a variety of operating conditions.
Brass body construction.
3/8" threaded inlet and outlet connections.
the orifice is available in both standard and high capacity models.
MAXON spark ignitors for the Ovenpak 1 have been engineered specially for industrial burner applications. Quality construction provides maximum service life and dependable operation to keep your heating process running smoothly. Consult technical bulletins to ensure your setup is per manufacturer`s recommendation for your specific OP2 model.
Quick View
Quick View
Quick View
Quick View
Quick View
Quick View
Quick View
Quick View
Quick View
Quick View